|
Post by osidak on Aug 22, 2012 20:28:50 GMT -4
Well I think my erazor 450 may have come to the point where it needs to be EOL'ed (end of lifed) I had a big crash about a month ago - I put ~ $50 worth of parts back into it (total cost of heli was $169 with crappy radio) and since then I have not been able to get the tracking right. I have replaced anything and everything that could have gotten bent except the actual head block and it will not track straight. I pulled everything apart again and made sure everything was absolutely level through out the full travel of the swash. Replaced all the linkage rods and made sure they where the same size and yet I still have blade tracking that is way off. I have the bearings for the main shaft that I could replace but there does not seem to be any play in the shaft - There is no run out in the shaft when I spool it up with or with out the head On my last pack last night and on todays flights as well the Gyro appears to have taken a (BAD WORD). I was using the JY401 that came with the 600 on it. Was working like a charm until the past two days. Now no matter the gain rate I get a pretty good wag - I can still keep it up but only in a hover. There are times that I take off and hover and it is fine and then I give it a little pitch bump and there comes the wag. So between the tracking and the now the gyro not sure I want to put anymore money into a cheap heli Though it was nice knowing if I totally rekitted the copter I wouldn't loose much
|
|
|
Post by Chris Reibert on Aug 22, 2012 21:19:05 GMT -4
I've got a Chaos 450Pro with your name on it. PM me for details if interested
|
|
|
Post by osidak on Aug 22, 2012 21:56:01 GMT -4
Thanks - already have one of those as well - just need to get around to making it flight worthy
|
|
|
Post by Chris Reibert on Aug 22, 2012 22:34:53 GMT -4
Get that baby done! You will love it!
|
|
|
Post by Dr. Evil on Aug 22, 2012 23:32:58 GMT -4
I been debating on putting my Erazor back together as well.
|
|