lee
PARK FLYER
Posts: 68
|
Post by lee on May 29, 2012 7:27:46 GMT -4
Hi Guys, I'm converting my 600 to FBL with the BeastX & Black Widow head.. I still have the stock Towerpro servos MG958 cyclic and tail and need to know the frequency. I know the pulse is 1520 but can't find the freq. Default on the BeastX is 50Hz. I know the cyclic and Tail servos have the same name but different speeds so that should be different too. Thanks for the help. Lee
|
|
|
Post by Dr. Evil on May 29, 2012 18:32:32 GMT -4
Hi Guys, I'm converting my 600 to FBL with the BeastX & Black Widow head.. I still have the stock Towerpro servos MG958 cyclic and tail and need to know the frequency. I know the pulse is 1520 but can't find the freq. Default on the BeastX is 50Hz. I know the cyclic and Tail servos have the same name but different speeds so that should be different too. Thanks for the help. Lee Just spend the last 30 min. trying to help you out by finding the frequency for those servos but no luck. That said, I do want to point out those so call "TowerPro" are actually "Phoenixtech" DS601M (cyclic) and DS602M (tail) servos miss badged. As you can see in the picture from this link here.... www.acmehobbies.com.au/magento/servos-gyros/phoenixtech-601m-digital-metal-gear-standard-servo.htmlThis is besides the point b/c it doesn't answer your question. I will try and do alittle more research but perhaps others can chim in as I know there are a few guys out there that have done exactly what you're planning to do.
|
|
lee
PARK FLYER
Posts: 68
|
Post by lee on May 30, 2012 3:22:20 GMT -4
Thanks Dr E I did the same, searching everywhere but no luck.
|
|