|
Post by Valkman on May 11, 2013 6:03:00 GMT -4
|
|
|
Post by edintexas on May 12, 2013 7:00:21 GMT -4
Valkman, Did you replace the lower main shaft bearing as well? I'd like to order some of these to be there when I'm home on leave but I don't know the diameter of the lower main shaft. Can you tell me so I can order them? Also, the Align T-rex 600 manual show the tail shaft bearings to be 5x10x5mm. The link you posted is for a 5x10x4mm bearing. Are you sure it's correct? Thanks
|
|
|
Post by Valkman on May 12, 2013 16:41:49 GMT -4
The link I gave is correct not unless they have updated the tail. The 4 mm is the width. I just double checked . Not only that I upgraded the tail with the double pitch link control and that had to be bought for the V1 which comes with one of those bearings the same size. I have lots of 5 * 10 * 5 but they do not fit.
|
|