|
Post by chitty024 on Mar 9, 2013 14:58:51 GMT -4
Just got some balls and started doing back flips and loops with my 450 pro. However when I went to roll sideways it went suuuuuuuper slow but I got it over and hovered inverted for a sec before trying to roll it back over and planting it in some tall grass. Good thing is I only took out the landing gear and put a couple nicks in the blades. What do I need to adjust to get it to roll faster? I am using the ZYX unit.
|
|
|
Post by Dr. Evil on Mar 9, 2013 15:58:22 GMT -4
I am no 3D pilot but only thing I can think of is to check and make sure there are no expo set, if anything I would say add some negative expo. What kind of servos are you using?
|
|
|
Post by Chris Reibert on Mar 9, 2013 16:47:08 GMT -4
Expo just softens up the center stick movement but you would still get full range of movement at the outside. I have never run negative expo I fly either 0 or 40% in idle 1+2. I had to turn my end points out on my mCPX from 100% to 125% giving it Awesome roll and flip rates. Also dual rates will give you more throw. Just make sure nothing mechanical binds!
|
|
|
Post by chitty024 on Mar 9, 2013 18:09:10 GMT -4
Expo just softens up the center stick movement but you would still get full range of movement at the outside. I have never run negative expo I fly either 0 or 40% in idle 1+2. I had to turn my end points out on my mCPX from 100% to 125% giving it Awesome roll and flip rates. Also dual rates will give you more throw. Just make sure nothing mechanical binds! Didn't think about end points. I figured it was something with the FBL controller because I don't know much about it yet.
|
|