3dd
ROOKIE
Posts: 1
|
Post by 3dd on Jan 27, 2012 18:33:02 GMT -4
i have my first heli built and am trying to program it,thought i had it pretty good,swash level at center and top and bottom,,but then i powered it up to go hover and when i give it left aileron the engine starts,when i center the ail stick it stops,,when i pull back on the el stick the engines runs,when i center the stick it stops,,what theck have i got wrong
|
|
|
Post by doconeheli2 on Feb 10, 2012 12:26:36 GMT -4
Hey 3dd, I'm not sure what radio ya have but sounds like to me you have "mode" set incorrectly. You should have mode 2 which puts the throttle on the left stick, not right. Or, the esc is in the wrong port on your reciever. I know there is more knowledgeable guys out there than can help. But check out your settings on your radio and your reciever.
|
|
|
Post by doc121 on Feb 10, 2012 23:48:05 GMT -4
Hi 3dd, like doconeheli2 said it sounds like your radio is set to mode 3. Take a look and see. If it in mode 3 change it to mode 2. Also like advised above check your receiver hook up. You may have accidentally hooked your esc to your aileron input. Happy flying!
|
|